1) melting loss
熔损
1.
The experimental results and analyses indicated that the hydrogen content of A00 melt after purification with JDN-I flux increased little with the increasing of heat preservation time, but the mechanical properties decreased sharply and the melting loss that was below 1% and far lower than that of flux A in the market increased suddenly when heat preservation time was above 100min.
在730℃温度下,用JDN I稀土熔剂对A00纯铝进行净化处理,结果表明,净化后的铝熔体氢含量随着保温时间的延长增加很小,纯铝的力学性能在保温100min后急剧降低,纯铝熔体的熔损在保温100min后,随着保温时间的增加也急剧升高,但远低于市售熔剂A,熔体熔损基本都保持在1%以下;该种熔剂对纯铝熔体最适宜的处理时间是小于100min。
2.
The melting loss has relations with size of melting bath,oxidation film property of melting charge,melting process and melting operation,etc,during melting aluminium alloy in reflecting frunace.
反射炉熔炼铝合金时，熔损与熔池几何尺寸、熔体氧化膜性质、熔炼工艺及操作等因素有关。
3.
The results showed that melting loss and abrasion were the main cause of tuyere failure.
对紫铜贯流式高炉风口的失效进行了分析,结果表明:熔损和磨损是高炉风口损坏的主要方式。
2) corrosion
[英][kə'rəuʒən] [美][kə'roʒən]
熔损
1.
The steel corrosion on MgO-SiC composites is studied in this article.
就熔融钢液对MgO-SiC复合材料的熔损进行了分析,实验后发现,熔钢对MgO-SiC复合材料有明显的熔蚀,对试验后耐火材料和钢液之间的反应层进行了X射线衍射分析、电镜和能谱分析。
3) melting
[英]['meltɪŋ] [美]['mɛltɪŋ]
熔损
1.
The results shows that melting and oxidation are the main reason of corrosion at the high temperature.
研究表明:高温熔损和高温氧化是衬套受蚀的主要原因。
4) Erosion
[英][i'rəuʒən] [美][ɪ'roʒən]
熔损
1.
Study on the Surface Treatment Process of H13 Type Hot Work Steel and Its Subsequent Thermal Fatigue and Erosion Behaviors;
热作模具钢（H13型）表面处理及其热疲劳、热熔损性能研究
5) melting loss
烧损，熔损
6) smelting of the burning-loss
熔炼烧损
补充资料：熔炼损耗
meltingloss：金属炉料在熔炼过程中，由于蒸发、氧化和扒渣时带走液态金属，所造成的损耗。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条