1) radiant tube
辐射管
1.
Numerical simulation of the recuperative radiant tube burner
自身预热式燃气辐射管的数值研究
2.
The research of hot-dip and then diffusion treated aluminizing on the surface of the austenitic heat-resistant steel CrNiNRE specially for the radiant tube of carburizing furnace was carried out.
采用表面电解活化助镀技术在渗碳炉辐射管用CrNiNRE奥氏体耐热钢表面进行了热浸扩散渗铝试验研究。
3.
This paper summarizes the types and materials of radiant tube.
对辐射管的类型和材质做了归纳,阐述了各种辐射管烧嘴供风方式的特点。
2) radiation tube
辐射管
1.
When repairing old seal up box type carburizing furnace, the furnace lining radiation tube etc.
在老式密封箱式渗碳炉的大修中更换了炉衬、辐射管等主要构件,利用原有的轨道、料盘、小车、推头、炉门、管道等构件,并进行触摸屏控制,用先进技术对老设备进行技术改造,各项技术性能指标均达到现代箱式渗碳炉的水平。
2.
Measurement and statistics show that deformation of the radiation tube in wardly coated with the glaze is lessened and its service life prolonged and its energy saving is prominent and the homogeneity of temperature is greatly improved as well.
测试和统计表明,辐射管变形减小,寿命延长,节能显著,温度均匀性得到很大改善。
3.
According to the experiments and the heat transfer model of the radiation tube, the distribution and change regularity of the tube wall temperature and the combustion gas temperature are investigated under different operating parameters.
本文以数学模型和实验为手段，研究了在不同操作参数的条件下，辐射管壁面温度和管内气体温度的分布状况及变化规律。
3) radiant-tube
辐射管
1.
Air can be preheated nearly 1 000 ℃ in the fired-natural gas radiant-tube.
天然气蓄热式辐射管可将助燃空气预热到接近1 000℃,如果不采取一些特殊的措施,烟气中NOx含量会很高。
2.
A mathematical model of heat transfer in batch type radiant-tube enameling furnace is established by imagine plane method and the calculation is made.
利用假想平面法建立了室式辐射管搪烧炉传热数学模型,并进行了仿真计算,结果表明,假想平面法能够大大简化室式辐射管搪烧炉内大量的角系数的计算,并可对炉子的有关参数(如辐射管的距径比、布置、炉墙结构等)进行优化计算。
4) radiation furnace pipe
辐射炉管
1.
The construction of radiation furnace pipes in an ethylene cracking furnace is a difficult task.
乙烯裂解炉辐射炉管的施工比较复杂,文章结合吉林石化分公司15万t／a乙烯装置节能改造项目的施工实践,介绍了辐射盘管系统施工的准备工作、辐射盘管组装顺序、集管箱开孔及组焊、猪尾管预制安装、辐射盘管吊装等方面的施工经验。
5) emission pipe
(热)辐射管
6) electric rediant tube
电辐射管
补充资料：管形总辐射表
管形总辐射表
tube-solarimeter
guanXing ZOng管形总辐射表fUSh6biaO (tube·solarimeter)对作物植株间辐射分布或透光率进行测定的仪器。用涂黑的温差电堆作为感受器，测定感受面上因辐射能产生的温差电流值，与绝对辐射仪器比较检定，得到换算系数，而求得辐射值。 (杨正明)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条