说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 氯丙烯
1)  allyl chloride
氯丙烯
1.
Eeffect of solvent on epoxidation of allyl chloride with hydrogen peroxide and titanium silicalite;
TS-1催化氯丙烯环氧化反应过程中的溶剂效应
2.
Development and utilization of allyl chloride and its derivatives;
氯丙烯及其衍生产品的开发和利用
3.
Correlation of nerve conduction velocity and lipid peroxidation induced by allyl chloride in rat sciatic nerve;
氯丙烯诱导的大鼠坐骨神经传导速度和脂质过氧化相关性
2)  chloropropene [,klɔ:rə'prəupi:n]
氯丙烯
1.
The preparation of supported liquid-phase platinum catalyst,and its catalytic property for hydro-(silylation) reaction of 3-chloropropene were studied.
研究了固载液相铂催化剂的制备及其在3-氯丙烯与甲基二氯硅烷硅氢加成反应中的催化性能;该催化剂对连续式气-固相硅氢加成反应具有极高的催化活性和稳定性。
3)  allyl chloride
烯丙基氯
1.
Allylsucrose was prepared by the reaction of sucrose with allyl chloride as the etherification agent in the presence of NaOH as an activating agent.
以蔗糖为原料,NaOH为活化剂对蔗糖进行活化预处理,烯丙基氯为醚化试剂,制备了烯丙基蔗糖(AS)。
2.
Flame retardant bis(4-allyloxy-3,5-dibromophenyl)sulfone(ATBS) with high yield and high mass fraction was obtained by etherization of bis(4-hydroxy-3,5-dibromophenyl)sulfone(TBS) with allyl chloride in the presence of alkaline medium and under low pressure(gauge pressure 0.
用四溴双酚S(TBS)和烯丙基氯为原料,在NaOH水介质中,低压条件下(表压0。
3.
High yield and purity flame retardant bis-(4-allyloxy-3,5-dibromophenyl)sulfone(ATBS) was obtained by allyl-etherizing bis-(4-hydrxy-3,5-dibromophenyl)sulfone(TBS) with dropping allyl chloride in aqueous NaOH in the presence of cetyltrimethylammonium bromide(CTAB) or other surfactants.
用四溴双酚S(TBS)为原料,以滴加方式加入醚化剂烯丙基氯,在NaOH水溶液中用十六烷基三甲基溴化铵(CTAB)催化醚化法和其它表面活性剂促进醚化法合成了收率、纯度均较高的阻燃剂四溴双酚S双烯丙基醚(ATBS)。
4)  acryloyl chloride
丙烯酰氯
1.
Synthesis of copolymer from acryloyl chloride graft on polyvinyl alcohol;
丙烯酰氯接枝聚乙烯醇纤维的合成及光谱研究
2.
Coupling reaction of living butadiene-styrene copolymers coupled with acryloyl chloride;
丙烯酰氯偶联活性丁苯共聚物
3.
A bioactive monomer 3, (± )-(E)-1-(2,4- dichlorophenyl)-2-(1,2,4-triazol-1-yl)-4,4-dimethyl-1-penten-3- ol-acrylate, was synthesized by reacting diniconazole 1 with acryloyl chloride 2, and its structure was confirmed by IR, MASS and 1H NMR spectroscopy.
以杀菌剂烯唑醇1为底物与丙烯酰氯2反应合成了具有生物活性的可聚合单体(±)-(E)-1-(2,4-二氯苯基)-2-(1,2,4-三唑-1-基)-4,4-二甲基-1-戊烯-3-醇丙烯酸酯3,以IR,MASS和1H NMR对其化学结构进行了表征。
5)  allylchloride
烯丙基氯
1.
The synthesis of allylamine based on the method of Delépine amine by the reaction of allylchloride in ethanol and hexamethylenetetramine in the presence of KI was investigated.
以Delépine伯胺制备方法为依据,用无水乙醇代替氯仿做溶剂,通过烯丙基氯与乌洛托品反应制备烯丙基胺。
2.
Butadiene was polymerized to some extent in the presence of binary catalyst system NdCl33iPrOHAlEt3 in toluene and the allylchloride was then added to the solution in order to cyclize the formed polybutadiene and cyclopolymerize the unreacted butadiene monomers.
采用NdCl3·3i-PrOH-AlEt3稀土催化剂进行丁二烯的顺式聚合,在聚合过程中引入烯丙基氯,进行分子内环化反应以及单体的环聚反应。
3.
The technological conditions of the synthesis of dimethyl diallylammonium chloride were studied taking allylchloride, dimethylamine and Aqueous solution of caustic soda as raw material.
本文以烯丙基氯、二甲胺、氢氧化钠为原料,探讨了合成二甲基二烯丙基氯化铵的工艺条件,研究了反应温度、反应时间、烯丙基氯加入方式对产物收率的影响,在一定的反应条件下,收率达85%以上。
6)  Allyl-chloride
烯丙氯
补充资料:氯丙烯
  分子式  ClCH2CH=CH2
   CAS号  107-05-1
   性质  无色易燃液体,有腐蚀性和刺激性嗅味。相对密度0.9382(20/4℃)。凝固点-134.5℃。沸点45℃。折射率nD(25℃)1.4160。粘度(20℃)0.336mPa·s。比热容(30℃)1.633J/(g·℃)。闪点(闭杯)-31.7℃。蒸汽压(20℃)39.396kPa。自燃点392℃。能发生氧化、加成、聚合、水解、氨化、氰化、酯化等反应。微溶于水,与乙醇、氯仿、乙醚和石油醚混溶。有毒!
    用途  化工原料。生产甘油、环氧氯丙烷、丙烯醇等的有机合成中间体,也是农药、医药的原料。还可用作合成树脂、涂料、胶粘剂、增塑剂、稳定剂、表面活性剂、土壤改良剂和香料的原料。
    毒性   蒸气刺激性强,麻醉作用弱,强烈刺激眼、鼻和咽喉。对肝脏损害小,对肺、肾的损害大。在卤代烃中,烯丙基氯是毒性大的物质。大鼠经口LD(50)0.7g/kg。大鼠吸入浓度为(3E-4)的蒸气,几小时内即可死亡。对豚鼠,浓度为10~100mg/L即强烈刺激粘膜,进而侵入肺部而致死。能经皮肤吸收,如果附着在衣服上必须立刻更换。操作人员应穿戴防护用具。工作场所空气中最高容许浓度1E-6(3mg/m3)。 
   包装储运  可用铁桶、槽车装运。贮槽应密闭存放于阴凉、通风处。防火、防爆、防晒、防泄漏。铁路、公路均可运输。按易燃有毒物品规定贮运。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条